
Motus by Mirus – Dual Sensor LED Strip (PCB)
Specification Sheets
Applications
- Stairwells
- Corridors
- Canopies
- Parking Garages
- Laundry Rooms
- Covered Parking
Features
- Low maintenance
- Adjustable Time Delay and range
- Dual 360°/ 26FT Detection Zone
- UL Listed
- DLC Listed
- 5 Year Warranty
Specifications
- Die formed 24 gauge cold rolled steel body
- Post painted with high gloss baked white matte powder coat
- Frosted diffuser
- Available in 2’or 4’
- Mounting: Chain or Cable Mount Ready (Cord and plug options offered)
Technical Information
- Light Source: LED Board
- Power Source: LED High Efficiency Power Supply
- Voltage: Universal 120 to 277
- CCT: 40K & 50K
- CRI: 83
- Driver capable of 0-10V dimming
- L70 Rated Life: 398,000
- Operating Temperature: -20°C – 40°C Ambient
Dimensions:
(2FT) D 3.43” x L 26.69” x W 2.36”
(4FT) D 3.43” x L 50.35” x W 2.36”
Safety Warning
FOR YOUR SAFETY, READ AND FOLLOW ALL INSTRUCTIONS TO PREVENT ELECTRIC SHOCK OR FIRE
- INSTALLATION REQUIRES KNOWLEDGE OF LIGHTING LUMINAIRE ELECTRICAL SYSTEMS – Contact qualified electrician prior to installation.
- DISCONNET POWER BEFORE INSTALLATION
- DO NOT ALTER PRE-EXISTING HOLES OR DRILL NEW HOLES
- CHECK FOR INCLOSED WIRING COMPONENTS PRIOR TO DRILLING: Luminaire wiring, ballasts, power supplies or other electrical parts may be damaged.
- USE ONLY ON COMPATIBLE LUMINAIRES: Installation requires specific dimensions and construction features.
- PROTECT WIRING FROM ABRASION: Do not expose wiring to sharp objects or edges of sheet metal.


Installation Instructions
- Disconnect power to the circuit supplying power to the
fixture - Removed the existing lamps and fixture
- Disassemble new fixture to allow access to the LED Driver
- Run existing power supply wires into fixture through fixture
knock-out or end plug on fixture - Mount the fixture to surface, or hang fixture with appropriate
fixture mounting hardware or install fixture in T-bar Ceiling
(Be sure to follow local building codes for the appropriate
fixture installation methods.) - Connect power supply wires to supplied wire disconnect to
provide power to fixture - Re-assemble fixture
- Re-connect power and check installation